ER5356
AWS A5.10 ER5356
EN ISO 18273 S Al 5356 (AlMg5Cr(A))
Description：
An Al-Mg alloy welding wire is mainly used where higher weld strength and greater ductility is required. 5356 has greater resistance to corrosion (salt water) and better color match after annodizing. DC Reversed Polarity connection. Argon shielding gas is required. Welding for 5xxx series alloys.
Diameters:
0.8mm, 0.9mm, 1.0mm, 1.2mm, 1.6mm.
Typical Mechanical Properties:
Tensile strength(MPa): | 265 |
Yield stress(MPa): | 120 |
Elongation(%): | 27 |
Impact values(≥47J/+20℃): | -- |
Typical Chemical Properties:
Si | Fe | Cu | Mn | Mg |
0.1 | 0.3 | 0.05 | 0.05-0.2 | 4.5-5.5 |
Cr | Zn | Be | Ti | Al |
0.1-0.15 | 0.09 | 0.0008 | 0.06-0.2 | Allowance |
Welding Current:(DC+)
Dia:(mm) | 0.8 | 0.9 | 1.0 | 1.2 | 1.6 |
Current/A | 60-170 | 90-210 | 140-260 | 190-350 | |
Voltage/V | 13-24 | 13-24 | 15-26 | 20-29 | 25-30 |
Note:
1.Rusty, oil stains, water and other impurity on the weld parts must be cleaned before welding.
2. Shield Gas:100%Ar or 75%Ar+25%He or 50%Ar+50%He
3. In order to get good welding bead, weld on thick plate should be preheat 100-200℃ before welding.
4. Tig rods ER5356 1.6mm, 2.0mm, 2.4mm, 3.2mm available
